Full range from 50W to 2000W, 220V – 240V, 50Hz or 60Hz.
Available for High Pressure Sodium Vapour (HPSV) Lamps, High Pressure Mercury Vapour (HPMV) Lamps and High Pressure Metal Halide (HPMH) Lamps.
Compact design of ballast make insulation into narrow control-gear compartment possible.
Polyester impregnated or air-cooled type design can provide effective heat dissipation.
PA66 Beige Nylon connector with galvanized surface treatment
Winding insulation Class H (200ºC and above) material.
Tropicalised.
Tested by SIRIM, Malaysia.
Approved by JKR, Malaysia and TNB, Malaysia.
Performance:
High Performance winding wire (tw 130) according to IEC 60992 in which an average life of 10 years can be expected (under normal conditions).
High grade low loss silicon electrical steel used for the ballast core material producing less heat and and low operating temperature (∆t), range of temperature rise are between (∆t 55 – ∆t 75).
Low power losses.
Non-audible noise level.
Quality:
100% final testing on continuity, winding short circuit, core to coil high voltage test and operating current.
Compliance:
IEC 60922 (International Std: General and Safety Requirements)
IEC 60923 (International Std: Performance Requirements)
MS IEC 60922:1995 (Malaysia Std: General and Safety Requirements)
MS IEC 60923:1995 (Malaysia Std: Performance Requirements)
Project Reference:
Petronas Twin Tower, Kuala Lumpur.
Kuala Lumpur International Airport (KLIA), Sepang.
